Slate Surface Roofing Installation

Compare homeowner reviews from 8 top los angeles natural slate roof install services.

Slate surface roofing installation.

Along the eaves and rakes positioning them. Srca which publishes section 07310 slate shingles setting forth architectural specifications for a slate roofing project the following in this section is adapted by srca from that document based on california slate company products. It was pretty easy to install and took about an hour to do by myself including setup and tear. Roof slates must be conditioned at a temperature no lower than 45 f for twenty four 24 hours prior to use.

A nu lok slate roof installation is more energy conserving as it is installed on a grid system that naturally ventilates the roof. This is not a how to video. Bought this roll from home depot. He choice of metals and fasteners should be consistent in material.

Do not chalk on the slates themselves. At the very least ask contractors to include a clause in their. Install every course of slates along a permanent red chalk line chalked on the surface of the roof that marks the top edge of the slates. The first course of slate should be installed even with the butt edge of the starter course.

Hire the best slate roof installers in los angeles ca on homeadvisor. Slate shingle specifications california slate is a proud member of the slate roofing contractors association of north america inc. Saturated felt as underlayment over the entire. Application place 9 side strips of roll roofing.

This ensures that nails are covered by the next course and no through joints from roof surface to underlayment are exposed. Slates may be installed at temperatures as low as 32 f hand fastened or with a pneumatic gun. Do not eyeball the courses. 2 and where ends join lap the felt 4.

The slate density helps to stabilize interior temperature and available integrated solar panels that set flush with the slates create a truly 21st century roof solution while retaining the traditional benefits of. Apply horizontally parallel to eaves lapping. The vertical joints between the starter and first course and all succeeding courses should be a minimum of 2.